0
Technical Brief

Forces in Green Micromachining of Aluminum Nitride Ceramics

[+] Author and Article Information
Recep Onler

Department of Mechanical Engineering, Carnegie Mellon University, 5000 Forbes Ave. Pittsburgh, PA, 15213
ronler@alumni.cmu.edu

Sundar V. Atre

Endowed Chair of Manufacturing and Materials, Professor of Mechanical Engineering, University of Louisville, 214 Shumaker Research Building, Louisville, KY 40292
sundar.atre@scipivision.com

Burak Ozdoganlar

Ver Planck Endowed Chair Professor of Mechanical Engineering, Professor of Biomedical Engineering, Professor of Materials Science and Engineering, Carnegie Mellon University, 5000 Forbes Ave. Pittsburgh, PA, 15213
ozdoganlar@cmu.edu

1Corresponding author.

ASME doi:10.1115/1.4043345 History: Received November 12, 2018; Revised March 25, 2019

Abstract

This paper presents an investigation of green micromachining forces during orthogonal micromachining green-state AlN ceramics. Green-state ceramics contain ceramic powders within a binder; processed samples are subsequently debound and sintered to obtain solid ceramic parts. An effective approach to create micro-scale features on ceramics is to use mechanical micromachining when the ceramics are at their green state. This approach, referred to as green micromachining (GMM), considerably reduces the forces and tool wear with respect to micromachining of sintered ceramics. As such, fundamental understanding on green micromachining of ceramics is critically needed. To this end, in this work, the force characteristics of powder injection molded AlN ceramics with two different binder states were experimentally investigated via orthogonal cutting. The effects of micromachining parameters on force components and specific energies were experimentally identified for a tungsten carbide and a single crystal diamond tools. As expected, the thrust forces were seen to be significantly larger than the cutting forces at low uncut chip thicknesses when using the carbide tool with its large edge radius. The cutting forces are found to be more sensitive to uncut chip thickness than the thrust forces are. When a sharp diamond tool is used, cutting forces are significantly larger than the thrust forces even for small uncut chip thicknesses. The specific energies follow an exponential decrease with increasing uncut chip thickness similar to the common trends in metal cutting. However, due to interaction characteristics between cutting edge and ceramic particles in the green body, evidence of ploughing and rubbing along the cutting region was observed even with a sharp diamond tool.

Copyright (c) 2019 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In