Large eddy simulation (LES) is employed in this paper to model the axial flow along a circular array of rods with a focus on anisotropic large-scale turbulence. The circular array consists of four whole rods and eight half rods, with a pitch-to-diameter ratio of 1.08. A dynamic Smagorinsky model with SIMPLE coupling method and a bounded central difference scheme are used to reduce numerical errors. The high demands for computations of the three-dimensional turbulent flows are afforded through parallel processing and utilization of 20 processors. The numerical results obtained using LES are compared with independent experimental data available in the literature; good agreement is achieved. The LES model was developed to accurately predict (i) the dependence of turbulence intensity and dominant frequency on the gap size and (ii) the turbulence structure in different directions.
Skip Nav Destination
e-mail: fabbasia@ryerson.ca
e-mail: syu@ryerson.ca
e-mail: jcao@ryerson.ca
Article navigation
February 2010
Research Papers
Large Eddy Simulation of Turbulent Axial Flow Along an Array of Rods
F. Abbasian,
F. Abbasian
Department of Mechanical and Industrial Engineering,
e-mail: fabbasia@ryerson.ca
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canada
Search for other works by this author on:
S. D. Yu,
S. D. Yu
Professor
Mem. ASME
Department of Mechanical and Industrial Engineering,
e-mail: syu@ryerson.ca
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canada
Search for other works by this author on:
J. Cao
J. Cao
Associate Professor
Department of Mechanical and Industrial Engineering,
e-mail: jcao@ryerson.ca
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canada
Search for other works by this author on:
F. Abbasian
Department of Mechanical and Industrial Engineering,
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canadae-mail: fabbasia@ryerson.ca
S. D. Yu
Professor
Mem. ASME
Department of Mechanical and Industrial Engineering,
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canadae-mail: syu@ryerson.ca
J. Cao
Associate Professor
Department of Mechanical and Industrial Engineering,
Ryerson University
, 350 Victoria Street, Toronto, ON M5B 2K3, Canadae-mail: jcao@ryerson.ca
J. Fluids Eng. Feb 2010, 132(2): 021105 (11 pages)
Published Online: February 16, 2010
Article history
Received:
August 11, 2008
Revised:
September 26, 2009
Online:
February 16, 2010
Published:
February 16, 2010
Citation
Abbasian, F., Yu, S. D., and Cao, J. (February 16, 2010). "Large Eddy Simulation of Turbulent Axial Flow Along an Array of Rods." ASME. J. Fluids Eng. February 2010; 132(2): 021105. https://doi.org/10.1115/1.4000574
Download citation file:
Get Email Alerts
Cited By
Related Articles
On Homogenization-Based Methods for Large-Eddy Simulation
J. Fluids Eng (December,2002)
Large Eddy Simulation of Constant Heat Flux Turbulent Channel Flow With Property Variations: Quasi-Developed Model and Mean Flow Results
J. Heat Transfer (February,2003)
Large Eddy Simulation of the Flow Behavior in a Simplified Helical Coil Steam Generator
J. Fluids Eng (February,2019)
Coarse Resolution Turbulence Simulations With Spectral Vanishing Viscosity—Large-Eddy Simulations (SVV-LES)
J. Fluids Eng (December,2002)
Related Proceedings Papers
Related Chapters
Formation of Absolute PBG of 2D Square Lattice by Changing the Shapes and Orientations of Rods
International Conference on Instrumentation, Measurement, Circuits and Systems (ICIMCS 2011)
Part 2, Section II—Materials and Specifications
Companion Guide to the ASME Boiler and Pressure Vessel Code, Volume 1, Third Edition
Part 2, Section II—Materials and Specifications
Companion Guide to the ASME Boiler & Pressure Vessel Code, Volume 1, Second Edition