Abstract

In this paper, we present an experimental and numerical investigation of a single-stage centripetal pump (SSCP). This SSCP is designed to operate in the pump regime, while forcing the working media through impeller-stator flow channels in the radial inward direction. The measured performance curves are characterized by a hysteresis, since the throttle-closing performance curves do not correspond to the throttle-opening performance curves throughout the whole operating range. A computational fluid dynamics (CFD) model was developed to establish these throttle-closing and throttle-opening performance curves. The flow conditions obtained with the CFD simulations confirm that the hydraulic behavior of the SSCP is influenced by the partial circumferential stall that occurs in the impeller-stator flow channels. It was shown that the inflow conditions to the impeller-stator assembly considerably influence the flow rate of the stall cessation, the size of the hysteresis, and the head generated during part-load operations.

1.
Sekavčnik
,
M.
, 1998, “
Radial Turbine for Smaller Power
,” Ph.D. thesis, Faculty of Mechanical Engineering, University of Ljubljana, Slovenia.
2.
Sekavčnik
,
M.
,
Tuma
,
M.
, and
Florjančič
,
D.
, 1998, “
Characteristics of One Stage Radial Centrifugal Turbine
,”
Proceedings of the ASME 1998 International Gas Turbine and Aeroengine Congress & Exhibition
, Stockholm, Sweden.
3.
Sekavčnik
,
M.
,
Tuma
,
M.
, and
Florjančič
,
D.
, 1999, “
Messtechnische Untersuchungen einer einstufigen Radialturbine
,”
Forsch. Ingenieurwes.
0015-7899,
65
(
1
), pp.
13
19
.
4.
Sekavčnik
,
M.
,
Drobnic
,
B.
, and
Tuma
,
M.
, 2002, “
Numerical Investigation of Single Stage Radial Centrifugal Turbine
,”
Proceedings of the First International Conference on Heat Transfer, Fluid Mechanics, and Thermodynamics
, Kruger Park, South Africa.
5.
Petermann
,
H.
, 1951, “
Untersuchungen am Zentripetalrad fuer Kreiselverdichter
,”
Forsch. Geb. Ingenieurwes.
0367-2204,
17
(
2
), pp.
51
59
.
6.
Pfleiderer
,
C.
, 1961, “
Die Kreiselpumpen fuer Fluessigketen und Gase
,”
5. Auflage
,
Springer-Verlag
,
Berlin
, pp.
235
236
.
7.
Gantar
,
T.
, and
Sekavčnik
,
M.
, 2007, “
Operating Regimes of an Unconventional Radial Pump Stage
,”
Forsch. Ingenieurwes.
0015-7899,
71
(
2
), pp.
89
97
.
8.
Gantar
,
T.
, and
Sekavčnik
,
M.
, 2008, “
Hydraulic Behaviour of Unconventional Radial Pump Stages
,”
Trans. Can. Soc. Mech. Eng.
0315-8977,
32
(
2
), pp.
155
179
.
9.
Gantar
,
T.
, 2008, “
Energy Characteristics of Radial Turbomachinery With Unconventional Flow Direction
,” Ph.D. thesis, Faculty of Mechanical Engineering, University of Ljubljana, Slovenia.
10.
Knapp
,
R. T.
, 1937, “
Complete Characteristics of Centrifugal Pumps and Their Use in the Prediction of Transient Behavior
,”
Mech. Eng. (Am. Soc. Mech. Eng.)
0025-6501,
59
(
8
), pp.
683
689
.
11.
Knapp
,
R. T.
, 1938, “
Complete Characteristics of Centrifugal Pumps and Their Use in the Prediction of Transient Behavior
,”
Mech. Eng. (Am. Soc. Mech. Eng.)
0025-6501,
60
(
8
), pp.
676
680
.
12.
Stepanoff
,
A. J.
, 1957,
Centrifugal and Axial Flow Pumps
, 2nd ed.,
Wiley
,
New York
, pp.
269
285
.
13.
Karassik
,
I. J.
,
Messina
,
J. P.
,
Cooper
,
P.
, and
Heald
,
C. C.
, 2001,
Pump Handbook
, 3rd ed.,
McGraw-Hill
,
New York
, pp.
2.376
2.382
.
14.
Guelich
,
J. F.
, 1999,
Kreiselpumpen, Ein Handbuch fuer Entwicklung, Anlageplanung und Betrieb, 1
,
Springer
,
Berlin
, pp.
54
112
.
15.
Gantar
,
T.
,
Sekavčnik
,
M.
, and
Mori
,
M.
, 2008, “
Numerical and Experimental Investigation of a Single Stage Centripetal Pump
,”
Forsch. Ingenieurwes.
0015-7899,
72
(
1
), pp.
53
65
.
16.
1991, “
Measurement of Fluid Flow by Means of Pressure Differential Devices—Part 1: Orifice Plates, Nozzles and Venturi Tubes Inserted in Circular Cross-Section Conduits Running Full
,” ISO 5167, 1st ed.
17.
Muggli
,
F. A.
,
Holbein
,
P.
, and
Dupont
,
P.
, 2002, “
CFD Calculation of a Mixed Flow Pump Characteristic From Shutoff to Maximum Flow
,”
ASME J. Fluids Eng.
0098-2202,
124
(
3
), pp.
798
802
.
18.
Gugau
,
M.
, 2004, “
Ein Beitrag zur Validierung der numerischen Berechnung von Kreiselpumpen
,” Ph.D. thesis, Techische Universitaet Darmstadt, Deutschland.
19.
Adami
,
P.
,
Della Gatta
,
S.
,
Martelli
,
F.
,
Bertolazzi
,
L.
,
Maestri
,
D.
,
Marenco
,
G.
, and
Piva
,
A.
, 2005, “Multistage Centrifugal Pumps: Assessment of a Mixing Plane Method for CFD Analysis,” 60°Congresso Nazionale ATI, Rome, Italy.
20.
Braun
,
O.
,
Kueny
,
J. L.
, and
Avellan
,
F.
, 2005, “
Numerical Analysis of Flow Phenomena Related to the Unstable Energy-Discharge Characteristic of a Pump-Turbine in Pump Mode
,” ASME Fluids Engineering Division Summer Meeting, Houston, TX.
21.
ANSYS CFX Help
, 2005,
ANSYS CFX-Solver, Release 10.0: Modelling
,
ANSYS Europe Ltd.
,
Waterloo, Ontario, Canada
, pp.
136
137
.
22.
1999, “
Rotodynamic Pumps—Hydraulic Performance acceptance Tests—Grades 1 and 2
,” ISO 9906.
23.
Celik
,
B. I.
,
Ghia
,
U.
,
Roache
,
P. J.
, and
Freitas
,
C. J.
, “
Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD Applications
,” Journal of Fluids Engineering Editorial Policy Statement on the Control of Numerical Accuracy, www.asme.orgwww.asme.org
24.
Day
,
I. J.
, 2004, “
Stall and Surge
,”
Cambridge Turbomachinery Course
,
University of Cambridge
,
Cambridge, England
.
25.
Day
,
I. J.
,
Greitzer
,
E. M.
, and
Cunpsty
,
N. A.
, 1978, “
Prediction of Compressor Performance in Rotating Stall
,”
ASME J. Eng. Power
0022-0825,
100
(
1
), pp.
1
14
.
26.
Greitzer
,
E. M.
, 1978, “
Surge and Rotating Stall in Axial Flow Compressors, Part I: Theoretical Compression System Model
,”
ASME J. Eng. Power
0022-0825,
98
(
2
), pp.
190
198
.
27.
Greitzer
,
E. M.
, 1978, “
Surge and Rotating Stall in Axial Flow Compressors, Part II: Experimental Results and Comparison With Theory
,”
ASME J. Eng. Power
0022-0825,
98
(
2
), pp.
199
217
.
28.
Idelchik
,
I. E.
, 1986,
Handbook of Hydraulic Resistance
, 2nd ed.,
Hemisphere
,
WA
, pp.
425
459
.
You do not currently have access to this content.