Fouling of compressor blades is an important mechanism leading to performance deterioration in gas turbines over time. Fouling is caused by the adherence of particles to airfoils and annulus surfaces. Particles that cause fouling are typically smaller than 2 to 10 microns. Smoke, oil mists, carbon, and sea salts are common examples. Fouling can be controlled by appropriate air filtration systems, and can often be reversed to some degree by detergent washing of components. The adherence of particles is impacted by oil or water mists. The result is a build up of material that causes increased surface roughness and to some degree changes the shape of the airfoil (if the material build up forms thicker layers of deposits), with subsequent deterioration in performance. Fouling mechanisms are evaluated based on observed data, and a discussion on fouling susceptibility is provided. A particular emphasis will be on the capabilities of modern air filtration systems.
Skip Nav Destination
Article navigation
March 2012
Research Papers
Fouling Mechanisms in Axial Compressors
Rainer Kurz,
Rainer Kurz
Solar Turbines Incorporated,
San Diego
, CA 92101
Search for other works by this author on:
Klaus Brun
Klaus Brun
Southwest Research Institute,
San Antonio
, TX 78238
Search for other works by this author on:
Rainer Kurz
Solar Turbines Incorporated,
San Diego
, CA 92101
Klaus Brun
Southwest Research Institute,
San Antonio
, TX 78238J. Eng. Gas Turbines Power. Mar 2012, 134(3): 032401 (9 pages)
Published Online: January 3, 2012
Article history
Revised:
May 1, 2011
Received:
May 1, 2011
Online:
January 3, 2012
Published:
January 3, 2012
Citation
Kurz, R., and Brun, K. (January 3, 2012). "Fouling Mechanisms in Axial Compressors." ASME. J. Eng. Gas Turbines Power. March 2012; 134(3): 032401. https://doi.org/10.1115/1.4004403
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Compressor Fouling Modeling: Relationship Between Computational Roughness and Gas Turbine Operation Time
J. Eng. Gas Turbines Power (May,2012)
Numerical Analysis of the Effects of Nonuniform Surface Roughness on Compressor Stage Performance
J. Eng. Gas Turbines Power (July,2011)
Impact of Surface Roughness on Compressor Cascade Performance
J. Fluids Eng (June,2010)
Computational Fluid Dynamics Simulation of Fouling on Axial Compressor Stages
J. Eng. Gas Turbines Power (July,2010)
Related Chapters
Other Components and Variations
Axial-Flow Compressors
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Introduction
Design and Analysis of Centrifugal Compressors