Surrogates development is important to extensively investigate the combustion behavior of fuels. Development of comprehensive surrogates has been focusing on matching chemical and physical properties of their target fuel to mimic its atomization, evaporation, mixing, and auto-ignition behavior. More focus has been given to matching the derived cetane number (DCN) as a measure of the auto-ignition quality. In this investigation, we carried out experimental validation of a three-component surrogate for Sasol-Isoparaffinic Kerosene (IPK) in ignition quality tester (IQT) and in an actual diesel engine. The surrogate fuel is composed of three components (46% iso-cetane, 44% decalin, and 10% n-nonane on a volume basis). The IQT experiments were conducted as per ASTM D6890-10a. The engine experiments were conducted at 1500 rpm, two engine loads, and two injection timings. Analysis of ignition delay (ID), peak pressure, peak rate of heat release (RHR), and other combustion phasing parameters showed a closer match in the IQT than in the diesel engine. Comparison between the surrogate combustion behavior in the diesel engine and IQT revealed that matching the DCN of the surrogate to its respective target fuel did not result in the same negative temperature coefficient (NTC) profile—which led to unmatched combustion characteristics in the high temperature combustion (HTC) regimes, despite the same auto-ignition and low temperature combustion (LTC) profiles. Moreover, a comparison between the combustion behaviors of the two fuels in the IQT is not consistent with the comparison in the diesel engine, which suggests that the surrogate validation in a single-cylinder diesel engine should be part of the surrogate development methodology, particularly for low ignition quality fuels.
Skip Nav Destination
Article navigation
August 2018
Research-Article
Experimental Validation of a Three-Component Surrogate for Sasol-Isoparaffinic Kerosene in Single Cylinder Diesel Engine and Ignition Quality Tester
Samy Alkhayat,
Samy Alkhayat
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Samy.alkhayat1@gmail.com
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Samy.alkhayat1@gmail.com
Search for other works by this author on:
Manan Trivedi,
Manan Trivedi
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: manan.trivedi2@wayne.edu
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: manan.trivedi2@wayne.edu
Search for other works by this author on:
Naeim Henein,
Naeim Henein
Mechanical Engineering,
Wayne State University,
Detroit, MI 48202
e-mail: henein@eng.wayne.edu
Wayne State University,
5050 Anthony Wayne Drive, Room 2121
,Detroit, MI 48202
e-mail: henein@eng.wayne.edu
Search for other works by this author on:
Sampad Mukhopadhyay,
Sampad Mukhopadhyay
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Sampad.gre@gmail.com
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Sampad.gre@gmail.com
Search for other works by this author on:
Peter Schihl
Peter Schihl
Search for other works by this author on:
Samy Alkhayat
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Samy.alkhayat1@gmail.com
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Samy.alkhayat1@gmail.com
Manan Trivedi
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: manan.trivedi2@wayne.edu
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: manan.trivedi2@wayne.edu
Naeim Henein
Mechanical Engineering,
Wayne State University,
Detroit, MI 48202
e-mail: henein@eng.wayne.edu
Wayne State University,
5050 Anthony Wayne Drive, Room 2121
,Detroit, MI 48202
e-mail: henein@eng.wayne.edu
Sampad Mukhopadhyay
Mechanical Engineering,
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Sampad.gre@gmail.com
Wayne State University,
5050 Anthony Wayne Drive, Suite 2100,
Detroit, MI 48202
e-mail: Sampad.gre@gmail.com
Peter Schihl
Contributed by the IC Engine Division of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received November 3, 2017; final manuscript received February 26, 2018; published online May 11, 2018. Editor: David Wisler. This work is in part a work of the U.S. Government. ASME disclaims all interest in the U.S. Government's contributions.
J. Eng. Gas Turbines Power. Aug 2018, 140(8): 082801 (11 pages)
Published Online: May 11, 2018
Article history
Received:
November 3, 2017
Revised:
February 26, 2018
Citation
Alkhayat, S., Trivedi, M., Henein, N., Mukhopadhyay, S., and Schihl, P. (May 11, 2018). "Experimental Validation of a Three-Component Surrogate for Sasol-Isoparaffinic Kerosene in Single Cylinder Diesel Engine and Ignition Quality Tester." ASME. J. Eng. Gas Turbines Power. August 2018; 140(8): 082801. https://doi.org/10.1115/1.4039805
Download citation file:
Get Email Alerts
Cited By
Blade Excitation Alleviation of a Nozzleless Radial Turbine by Casing Treatment Based on Reduced Order Mode
J. Eng. Gas Turbines Power
Design And Testing of a Compact, Reverse Brayton Cycle, Air (R729) Cooling Machine
J. Eng. Gas Turbines Power
Experimental Study on Liquid Jet Trajectory in Cross Flow of Swirling Air at Elevated Pressure Condition
J. Eng. Gas Turbines Power
Related Articles
Influence of Injection Parameters and Operating Conditions on Ignition and Combustion in Dual-Fuel Engines
J. Eng. Gas Turbines Power (October,2018)
Quasi-Dimensional Diesel Engine Combustion Modeling With Improved Diesel Spray Tip Penetration, Ignition Delay, and Heat Release Submodels
J. Eng. Gas Turbines Power (November,2017)
Spray–Wall Interactions in a Small-Bore, Multicylinder Engine Operating With Reactivity-Controlled Compression Ignition
J. Eng. Gas Turbines Power (September,2018)
A Multicomponent Blend as a Diesel Fuel Surrogate for Compression Ignition Engine Applications
J. Eng. Gas Turbines Power (November,2015)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Physiology of Human Power Generation
Design of Human Powered Vehicles
Reciprocating Engine Performance Characteristics
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines