Hysteresis in five different Thermochromic Liquid Crystals (TLCs), both narrow-band and broad-band, has been investigated. All were found to exhibit a similar hysteresis behavior during cooling relative to heating. This hysteresis is characterized by a decrease in reflectivity and a shift in the temperature associated with the peak reflected intensity for each of the R, G, and B components during cooling. This causes a shift in the hue-temperature calibration of the TLC causing temperature biases, when cooled rather than heated, of 20–60% of the useful calibration range. The hysteresis effect increases as the peak temperature during a heating and cooling cycle is increased. Repeatable heating calibrations were obtained when the TLC was cooled below the red start temperature to an apparent low reset temperature. Somewhat repeatable cooling calibrations, different from the heating calibrations, were obtained when the TLC was heated somewhat above the blue stop temperature. A possible explanation of the hysteresis based on the texture of the liquid crystal helices is provided. In addition to hysteresis, a permanent decrease in reflectivity and a shift in the temperature associated with the peak reflected intensity was observed when the TLCs were exposed to extended higher temperatures (60°C–80°C).
Skip Nav Destination
e-mail: mike.anderson@ps.ge.com
e-mail: jwbaughn@ucdavis.edu
Article navigation
Technical Papers
Hysteresis in Liquid Crystal Thermography
M. R. Anderson,
e-mail: mike.anderson@ps.ge.com
M. R. Anderson
GE Optimization Services, 1631 Bently Parkway South, Minden NV 89423
Search for other works by this author on:
J. W. Baughn, Professor, Fellow ASME,
e-mail: jwbaughn@ucdavis.edu
J. W. Baughn, Professor, Fellow ASME,
Department of Mechanical and Aeronautical Engineering, University of California, Davis, One Shields Avenue, Davis CA 95616
Search for other works by this author on:
M. R. Anderson
GE Optimization Services, 1631 Bently Parkway South, Minden NV 89423
e-mail: mike.anderson@ps.ge.com
J. W. Baughn, Professor, Fellow ASME,
Department of Mechanical and Aeronautical Engineering, University of California, Davis, One Shields Avenue, Davis CA 95616
e-mail: jwbaughn@ucdavis.edu
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division July 23, 2001; revision received February 23, 2004. Associate Editor: D. B. R. Kenning.
J. Heat Transfer. Jun 2004, 126(3): 339-346 (8 pages)
Published Online: June 16, 2004
Article history
Received:
July 23, 2001
Revised:
February 23, 2004
Online:
June 16, 2004
Citation
Anderson, M. R., and Baughn, J. W. (June 16, 2004). "Hysteresis in Liquid Crystal Thermography ." ASME. J. Heat Transfer. June 2004; 126(3): 339–346. https://doi.org/10.1115/1.1738425
Download citation file:
Get Email Alerts
Cited By
Related Articles
A Novel Mini Calibrator for Thermochromic Liquid Crystals
J. Heat Transfer (June,2001)
Three-Dimensional Visualization and Measurement of Temperature Field Using Liquid Crystal Scanning Thermography
J. Heat Transfer (October,2001)
Thermoreflectance Measurement of Temperature and Thermal Resistance of Thin Film Gold
J. Heat Transfer (November,2012)
Related Proceedings Papers
Micro-Raman Thermometry of Laser Heated Surfaces
InterPACK2007
Related Chapters
EVALUATION OF THERMAL PROBE COOLING EFFECT BASED ON PIPELINE PARALLEL OPTICAL CABLE
Pipeline Integrity Management Under Geohazard Conditions (PIMG)
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Chitosan-Based Drug Delivery Systems
Chitosan and Its Derivatives as Promising Drug Delivery Carriers