A new experimental method for three-dimensional cutting analysis based on times series models and the Dynamic Data System methodology is introduced. Its theoretical formulation allows the treatment of both orthogonal and three-dimensional cutting without any additional complexity. Furthermore, it facilitates an easy explanation and proof of the independence of the inner and outer modulation effects and the use of a simple experimental setup. It is shown that the overall transfer matrix of the three-dimensional cutting process relating the force and relative displacement components can be identified in a single experiment. Based on the proposed theoretical models of the cutting process, suitable experimental procedures and methods were proposed and used in actual cutting. The obtained results confirmed the theoretical expectations.
Skip Nav Destination
Article navigation
November 1985
This article was originally published in
Journal of Engineering for Industry
Research Papers
Analysis of Three-Dimensional Cutting Process Dynamics
X. G. Yang,
X. G. Yang
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
Search for other works by this author on:
K. F. Eman,
K. F. Eman
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
Search for other works by this author on:
S. M. Wu
S. M. Wu
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
Search for other works by this author on:
X. G. Yang
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
K. F. Eman
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
S. M. Wu
University of Wisconsin-Madison, Mechanical Engineering Department, Madison, WI 53706
J. Eng. Ind. Nov 1985, 107(4): 336-342
Published Online: November 1, 1985
Article history
Received:
March 19, 1985
Online:
July 30, 2009
Citation
Yang, X. G., Eman, K. F., and Wu, S. M. (November 1, 1985). "Analysis of Three-Dimensional Cutting Process Dynamics." ASME. J. Eng. Ind. November 1985; 107(4): 336–342. https://doi.org/10.1115/1.3186006
Download citation file:
Get Email Alerts
Cited By
Related Articles
Mechanics and Dynamics of Serrated Cylindrical and Tapered End Mills
J. Manuf. Sci. Eng (May,2004)
Whirling Vibrations in Boring Trepanning Association Deep Hole Boring Process: Analytical and Experimental Investigations
J. Manuf. Sci. Eng (February,2007)
Flank Wear and Process Characteristic Effect on System Dynamics in Turning
J. Manuf. Sci. Eng (February,2004)
A Comprehensive Dynamic End Milling Simulation Model
J. Manuf. Sci. Eng (February,2006)
Related Proceedings Papers
Related Chapters
System Constraints and Virtual Displacement
Dynamics of Particles and Rigid Bodies: A Self-Learning Approach
Application of the V R Resistance Curve Method to Fracture of Various Crack Configurations
Fracture Mechanics: Eighteenth Symposium
Dynamic Displacement and Pressure Distribution in Alpine Ski Boots
Skiing Trauma and Safety: Eighth International Symposium