Numerical simulation enables the optimization of a solar collector without the expense of building prototypes. This study details an approach using computational fluid dynamics (CFD) to simulate the performance of a solar thermal collector. Inputs to the simulation include; heat loss coefficient, irradiance, and ambient temperature. A simulated thermal efficiency was validated using experimental results by comparing the calculated heat removal factor. The validated methodology was then applied to five different inlet configurations of a header–riser collector. The most efficient designs had uniform flow through the risers. The worst performing configurations had low flow rates in the risers that led to high surface temperatures and poor thermal efficiency. The calculated heat removal factor differed by between 4.2% for the serpentine model and 12.1% for the header–riser. The discrepancies were attributed to differences in thermal contact between plate and tubes in the simulated and actual design.

References

1.
Duffie
,
J.
, and
Beckman
,
W.
,
1991
,
Solar Engineering of Thermal Processes
,
Wiley
,
New York
.
2.
Tagliafico
,
L. A.
,
Scarpa
,
F.
, and
De Rosa
,
M.
,
2014
, “
Dynamic Thermal Models and CFD Analysis for Flat-Plate Thermal Solar Collectors—A Review
,”
Renewable Sustainable Energy Rev.
,
30
, pp.
526
537
.
3.
Fan
,
J.
,
Shah
,
L. J.
, and
Furbo
,
S.
,
2007
, “
Flow Distribution in a Solar Collector Panel With Horizontally Inclined Absorber Strips
,”
Sol. Energy
,
81
(
12
), pp.
1501
1511
.
4.
Selmi
,
M.
,
Al-Khawaja
,
M. J.
, and
Marafia
,
A.
,
2008
, “
Validation of CFD Simulation for Flat Plate Solar Energy Collector
,”
Renewable Energy
,
33
(
3
), pp.
383
387
.
5.
Reynolds
,
D. J.
,
Jance
,
M. J.
,
Behnia
,
M.
, and
Morrison
,
G. L.
,
2004
, “
An Experimental and Computational Study of the Heat Loss Characteristics of a Trapezoidal Cavity Absorber
,”
Sol. Energy
,
76
(
1
), pp.
229
234
.
6.
Iordanou
,
G.
,
2009
, “
Flat-Plate Solar Collectors for Water Heating With Improved Heat Transfer for Application in Climatic Conditions of the Mediterranean Region
,” Ph.D. thesis, Durham University, Durham, UK.
7.
Marroquin
,
J. A.
,
Olivares-Ramrez
,
J. M.
,
Omar
,
J. S.
,
Zamora-Antuñano
,
M. A.
, and
Encinas-Oropesa
,
A.
,
2013
, “
Analysis of Flow and Heat Transfer in a Flat Solar Collector With Rectangular and Cylindrical Geometry Using CFD
,”
Ingenierá Investigación Tecnol.
,
14
(
4
), pp.
553
561
.
8.
Dovic
,
D.
, and
Andrassy
,
M.
,
2012
, “
Numerically Assisted Analysis of Flat and Corrugated Plate Solar Collectors Thermal Performances
,”
Sol. Energy
,
86
(
9
), pp.
2416
2431
.
9.
Martinopoulos
,
G.
,
Missirlis
,
D.
,
Tsilingiridis
,
G.
,
Yakinthos
,
K.
, and
Kyriakis
,
N.
,
2010
, “
CFD Modeling of a Polymer Solar Collector
,”
Renewable Energy
,
35
(
7
), pp.
1499
1508
.
10.
Vasudeva Karanth
,
K.
,
Manjunath
,
M. S.
, and
Yagnesh Sharma
,
N.
,
2011
, “
Numerical Simulation of a Solar Flat Plate Collector Using Discrete Transfer Radiation Model (Dtrm)—A CFD Approach
,” World Congress on Engineering (
WCE
), London, July 6–8, Vol.
3
, pp.
6
8
.http://www.iaeng.org/publication/WCE2011/WCE2011_pp2355-2360.pdf
11.
Manjunath
,
M. S.
,
Karanth Vasudeva
,
K.
, and
Sharma
,
Y. N.
,
2011
, “
Three Dimensional Numerical Analysis of Conjugate Heat Transfer for Enhancement of Thermal Performance Using Finned Tubes in an Economical Unglazed Solar Flat Plate Collector
,”
World Congress on Engineering 2011
(
WCE
), London, July 6–8.http://www.iaeng.org/publication/WCE2011/WCE2011_pp2245-2249.pdf
12.
Turgut
,
O.
, and
Onur
,
N.
,
2009
, “
Three Dimensional Numerical and Experimental Study of Forced Convection Heat Transfer on Solar Collector Surface
,”
Int. Commun. Heat Mass Transfer
,
36
(
3
), pp.
274
279
.
13.
Allan
,
J.
,
Dehouche
,
Z.
,
Stankovic
,
S.
, and
Mauricette
,
L.
,
2015
, “
Performance Testing of Thermal and Photovoltaic Thermal Solar Collectors
,”
Energy Sci. Eng.
,
3
(
4
), pp.
310
326
.
14.
Cengel
,
Y. A.
,
1998
,
Heat Transfer a Practical Approach
,
McGraw-Hill
,
New York
.
15.
Jones
,
G. F.
, and
Lior
,
N.
,
1994
, “
Flow Distribution in Manifolded Solar Collectors With Negligible Buoyancy Effects
,”
Sol. Energy
,
52
(
3
), pp.
289
300
.
16.
Weitbrecht
,
V.
,
Lehmann
,
D.
, and
Richter
,
A.
,
2002
, “
Flow Distribution in Solar Collectors With Laminar Flow Conditions
,”
Sol. Energy
,
73
(
6
), pp.
433
441
.
17.
Wang
,
X. A.
, and
Wu
,
L. G.
,
1990
, “
Analysis and Performance of Flat-Plate Solar Collector Arrays
,”
Sol. Energy
,
45
(
2
), pp.
71
78
.
18.
Duffie
,
J. A.
, and
Beckman
,
W. A.
,
2013
,
Solar Engineering of Thermal Processes
, 4th ed.,
Wiley
,
New York
.
19.
Alanod Solar
,
2012
, “
Microtherm Absorber Fact Book
,” Alanod Solar, Ennepetal, Germany.
You do not currently have access to this content.