A validated computational model was created to simulate the heat transfer from a heated surface using liquid metals and alloys during conjugate heat transfer. This model explores the effect of the Rayleigh number, Prandtl number, thermal conductivity ratio, and aspect ratio on the Nusselt number along the hot surface. The data will show how to keep the temperature sensitive components along the hot wall cool by maximizing the amount of heat removed from the hot wall. The data show three distinct regions that occur as a function of the Rayleigh number for a fixed and . The data also show that the thermal conductivity ratio between the fluid and the solid conducting block has little effect on the Nusselt number at a fixed Rayleigh number. However, when examining the effect of the aspect ratio on the Nusselt number, two distinct regions can be seen. The results demonstrate that in order to keep the temperature sensitive components cool along the hot wall, one would want to have large Rayleigh and Prandtl numbers. The easiest way to achieve large Rayleigh numbers is by increasing the height of the enclosure. Large Prandtl numbers can be achieved by choosing a fluid that is highly conductive. In addition, the choice of material for the center solid conducting block does not impact the amount of heat removed from the hot wall. However, increased cooling can be achieved by decreasing the spacing between the hot and the cold wall.
Skip Nav Destination
e-mail: mmcgarry@sandiego.edu
Article navigation
March 2010
Research Papers
Conjugate Heat Transfer Using Liquid Metals and Alloys for Enclosures With Solid Conducting Blocks
M. McGarry,
M. McGarry
Department of Engineering,
e-mail: mmcgarry@sandiego.edu
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110
Search for other works by this author on:
C. Bonilla,
C. Bonilla
Department of Engineering,
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110
Search for other works by this author on:
I. Metzger
I. Metzger
Department of Engineering,
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110
Search for other works by this author on:
M. McGarry
Department of Engineering,
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110e-mail: mmcgarry@sandiego.edu
C. Bonilla
Department of Engineering,
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110
I. Metzger
Department of Engineering,
University of San Diego
, 5998 Alcala Park Loma Hall, San Diego, CA 92110J. Thermal Sci. Eng. Appl. Mar 2010, 2(1): 011004 (6 pages)
Published Online: August 5, 2010
Article history
Received:
October 7, 2009
Revised:
July 6, 2010
Online:
August 5, 2010
Published:
August 5, 2010
Citation
McGarry, M., Bonilla, C., and Metzger, I. (August 5, 2010). "Conjugate Heat Transfer Using Liquid Metals and Alloys for Enclosures With Solid Conducting Blocks." ASME. J. Thermal Sci. Eng. Appl. March 2010; 2(1): 011004. https://doi.org/10.1115/1.4002113
Download citation file:
37
Views
Get Email Alerts
Cited By
Thermal Characteristics and Dryer Performance Analysis of Double Pass Solar Collector Powered by Copper and Iron Oxide
J. Thermal Sci. Eng. Appl (February 2025)
Design Optimization of a Shell-and-Tube Heat Exchanger Based on Variable Baffle Cuts and Sizing
J. Thermal Sci. Eng. Appl (February 2025)
Energy-Efficient Three-Wheel Bleedless Electrical Environmental Control System for a Passenger Aircraft
J. Thermal Sci. Eng. Appl (February 2025)
Related Articles
Natural Convection in Low Prandtl Number Fluids With a Vertical Magnetic Field
J. Heat Transfer (August,2000)
Three-Dimensional Conjugate Heat Transfer in a Horizontal Channel
With Discrete Heating
J. Heat Transfer (August,2004)
Enhanced Heat Conduction in Fluids Subjected to Sinusoidal Oscillations
J. Heat Transfer (May,1985)
A Boundary Element Method for Evaluation of the Effective Thermal Conductivity of Packed Beds
J. Heat Transfer (March,2007)
Related Proceedings Papers
Related Chapters
Thermal Interface Resistance
Thermal Management of Microelectronic Equipment, Second Edition
Thermal Interface Resistance
Thermal Management of Microelectronic Equipment
Study on Liquid Metal Cooling of Photovoltaic Cell
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)