This paper addresses the wear characteristics of the mixing tube of an abrasive-waterjet nozzle. An effective nozzle material should possess high values of both hardness and toughness. The mixing tube, which is where the abrasives are mixed, accelerated, and focused with the high-pressure waterjet, is the component in the abrasive-water jet nozzle that receives the greatest wear. Accelerated wear tests were conducted on relatively soft (steel) mixing tubes using a typical soft abrasive (garnet sand) and on harder (tungsten carbide) tubes using a harder abrasive material (aluminum oxide). A wide range of candidate tool materials, including several carbides and ceramics, was also tested using actual machining parameters. The tungsten carbide grades exhibited greater longevity than the harder ceramics, such as boron carbide, when garnet abrasives were used. The reverse trend was observed with aluminum oxide abrasives. Wear trends suggest that the wear mechanisms along the mixing tube change from erosion by particle impact at the upstream sections to abrasion at the downstream sections. Linear cutting tests were also conducted on several candidate nozzle materials to gain more information related to wear performance. It was found, for example, that the binder in tungsten carbide, which controls these properties, is a critical factor that also controls the lifetime of tungsten carbide mixing tubes.
Skip Nav Destination
Article navigation
July 1994
Research Papers
Observations of Wear of Abrasive-Waterjet Nozzle Materials
M. Hashish
M. Hashish
QUEST Integrated, Inc., 21414-68th Avenue South, Kent, WA 98032
Search for other works by this author on:
M. Hashish
QUEST Integrated, Inc., 21414-68th Avenue South, Kent, WA 98032
J. Tribol. Jul 1994, 116(3): 439-444 (6 pages)
Published Online: July 1, 1994
Article history
Received:
February 2, 1993
Revised:
December 14, 1993
Online:
June 5, 2008
Citation
Hashish, M. (July 1, 1994). "Observations of Wear of Abrasive-Waterjet Nozzle Materials." ASME. J. Tribol. July 1994; 116(3): 439–444. https://doi.org/10.1115/1.2928861
Download citation file:
Get Email Alerts
Environmentally Friendly MoS2-hBN Solid Lubricants: A Comprehensive Tribological Evaluation
J. Tribol (April 2025)
Machine Learning in Wear Prediction
J. Tribol (April 2025)
Static Characteristics of Hybrid Water-Lubricated Herringbone Groove Journal Bearing
J. Tribol (April 2025)
Related Articles
Improving Precision in Aluminum Alloy Machining Due to the Application of Diamond-Like Carbon Thin Film
J. Tribol (July,2021)
Predictive Models for Flank Wear on Coated Inserts
J. Tribol (January,2000)
Effect of Surface Properties Modification on Slurry Erosion–Corrosion Resistance of AISI 5117 Steel
J. Tribol (July,2015)
Wear Studies on TiC Coated Cemented Titanium Carbide Tools
J. Eng. Mater. Technol (January,1984)
Related Chapters
Surface Analysis and Tools
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
Study of the Effect of Machining Parameters on Material Removal Rate and Electrode Wear during Electric Discharge Machining of Mild Steel
International Conference on Computer and Automation Engineering, 4th (ICCAE 2012)
Wet-Sand Rubber-Wheel Abrasion Test for Thin Coatings
Selection and Use of Wear Tests for Coatings