An experimental investigation of the combined effects of upstream unsteady wakes and surface trips on the boundary layer development on an ultra-high-lift low-pressure turbine blade, known as T106C, is described. Due to the large adverse pressure gradient, the incoming wakes are not strong enough to periodically suppress the large separation bubble on the smooth suction surface of the T106C blade. Therefore, the profile loss is not reduced as much as might be possible. The first part of this paper concerns the parametric study of the effect of surface trips on the profile losses to optimize the surface trip parameters. The parametric study included the effects of size, type, and location of the surface trips under unsteady flow conditions. The surface trips were straight cylindrical wires, straight rectangular steps, wavy rectangular steps, or wavy cylindrical wires. The second part studies the boundary layer development on the suction surface of the T106C linear cascade blade with and without the recommended surface trips to investigate the loss reduction mechanism. It is found that the selected surface trip does not induce transition immediately, but hastens the transition process in the separated shear layer underneath the wakes and between them. In this way, the combined effects of the surface trip and unsteady wakes further reduce the profile losses. This passive flow control method can be used over a relatively wide range of Reynolds numbers.

1.
Schulte
,
V.
, and
Hodson
,
H. P.
, 1996, “
Unsteady Wake-Induced Boundary Layer Transition in High Lift LP Turbines
,” Proceedings of ASME Turbo Expo,
ASME
, New York, ASME Paper No. 96-GT-486.
2.
Howell
,
R. J.
,
Hodson
,
H. P.
,
Schulte
,
V.
,
Schiffer
,
H. P.
,
Haselbach
,
F.
, and
Harvey
,
N. W.
, 2001, “
Boundary Layer Development in the BR710 and BR715 LP Turbines: The Implementation of High Lift and Ultra High Lift Concepts
,”
ASME
, New York, ASME Paper No. 2001-GT-0441.
3.
Bons
,
J. P.
,
Sondergaard
,
R.
, and
Rivir
,
R. B.
, 2001, “
Turbine Separation Control Using Pulsed Vortex Generator Jets
,”
ASME J. Turbomach.
0889-504X,
123
(
2
), pp.
198
206
.
4.
Bons
,
J. P.
,
Sondergaard
,
R.
, and
Rivir
,
R. B.
, 2001, “
The Fluid Dynamics of LPT Blade Separation Control Using Pulsed Jets
,”
ASME
, New York, ASME Paper No. 2001-GT-0190.
5.
Volino
,
R. J.
, 2003, “
Separation Control on Low-Pressure Turbine Airfoils Using Synthetic Vortex Generator Jets
,”
ASME
, New York, ASME Paper No. GT-2003-38729.
6.
Lake
,
J. P.
,
King
,
P. I.
, and
Rivir
,
R. B.
, 2000, “
Low Reynolds Number Loss Reduction on Turbine Blades With Dimples and V-Grooves
,”
38th AIAA Aerospace Sciences Meeting and Exhibit
, AIAA-00-0738.
7.
Volino
,
R. J.
, 2003, “
Passive Flow Control on Low-Pressure Turbine Airfoils
,”
ASME
, New York, ASME Paper No. GT-2003-38728.
8.
Ramesh
,
O. N.
,
Hodson
,
H. P.
, and
Harvey
,
N. W.
, 2001, “
Separation Control in Ultra-High Lift Aerofoils by Unsteadiness and Surface Roughness
,” ISABE.
9.
Roman
,
K. M.
, 2003, “
The Effect of Roughness and Wake Unsteadiness on Low-Pressure Turbine Performance
,” MPhil thesis, Cambridge University, UK.
10.
Stieger
,
R. D.
, and
Hodson
,
H. P.
, 2003, “
Unsteady Dissipation Measurements on a Flat Plate Subject to Wake Passing
,”
5th European Turbomachinery Conference
.
11.
Zhang
,
X. F.
, and
Hodson
,
H. P.
, 2003, “
Parametric Study of Surface Roughness and Wake Unsteadiness on a Flat Plate with Large Pressure Gradient
,”
Proc. of 10th ISUAAAT
,
Duke University
.
12.
Stieger
,
R. D.
,
Hollis
,
D.
, and
Hodson
,
H. P.
, 2003, “
Unsteady Surface Pressures Due to Wake Induced Transition in a Laminar Separation Bubble on a LP Turbine Cascade
,”
ASME J. Turbomach.
0889-504X,
126
(
4
), pp.
544
550
.
13.
Stieger
,
R. D.
, and
Hodson
,
H. P.
, 2003, “
The Transition Mechanism of Highly-Loaded LP Turbine Blades
,”
ASME J. Turbomach.
0889-504X,
126
(
4
), pp.
536
543
.
14.
Bearman
,
P. W.
, 1971, “
Correction for the Effect of Ambient Temperature Drift on Hotwire Measurements in Incompressible Flow
,” DISA Information, No. 11, pp.
25
30
.
15.
Cox
,
R. N.
, 1957, “
Wall Neighborhood Measurements in Turbulent Boundary Layers Using Hot-wire Anemometer
,” A. R. C. Report 19101, Feb.
16.
Curtis
,
E. M.
,
Hodson
,
H. P.
,
Banieghbal
,
M. R.
,
Denton
,
J. D.
,
Howell
,
R. J.
, and
Harvey
,
N. W.
, 1997, “
Development of Blade Profiles for Low-Pressure Turbine Applications
,”
ASME J. Turbomach.
0889-504X,
119
, pp.
531
538
.
17.
Pinson
,
M. W.
, and
Wang
,
T.
, 2000, “
Effect of Two-Scale Roughness on Boundary Layer Transition Over a Heated Flat Plate: Part 1—Surface Heat Transfer
,”
ASME J. Turbomach.
0889-504X,
122
, pp.
301
307
.
18.
Pinson
,
M. W.
, and
Wang
,
T.
, 2000, “
Effect of Two-Scale Roughness on Boundary Layer Transition Over a Heated Flat Plate: Part 2—Boundary Layer Structure
,”
ASME J. Turbomach.
0889-504X,
122
, pp.
308
316
.
You do not currently have access to this content.