Abstract

The paper proposed an experimental measurement to identify the fluid-induced force and static stiffness coefficients. A three-dimensional fluid model of the labyrinth seals was also established. And the static characteristics under different eccentricities and inlet pressure were studied. Theoretical results show a good agreement with the experiment results. The labyrinth seal with different eccentricity ratios produces a de-centered fluid-induced force and a negative direct static stiffness, which cause the rotor deviating from the geometric center of the stator. Both the fluid-induced force and negative direct static stiffness coefficient with a value of −13.5 kN/m to −72 kN/m increase with increasing eccentricity and inlet pressure. Particularly, the direct static stiffness coefficient shows a relatively significant increase with a high eccentricity ratio (∼>40%). The static instability is mainly due to the fact that the fluid velocity in the small clearance increases more rapidly along the leakage path. The inertial force is increased significantly and the pressure decreases. This results in a greater pressure distribution in the larger clearance. The fluid force and direct static stiffness coefficient that tend to push the rotor away from the stator center are produced, and eventually lead to the static instability of the labyrinth seal.

References

1.
Schmied
,
J.
,
1988
,
Rotordynamic Stability Problems and Solutions in High Pressure Turbocompressors, Department/Division
,
College Station, TX
.
2.
Scharrer
,
J. K.
, and
Pelletti
,
J. M.
,
1995
, “
Leakage and Rotordynamic Effects of Compressible Annular Seals
,”
Proceedings of the Twenty-Fourth Turbomachinery Symposium
,
Houston, TX
,
Sept. 26–28
, pp.
175
190
.
3.
Lomakin
,
A. A.
,
1958
, “
Calculating of Critical Speed and Securing of Dynamic Stability of High Pressure Pumps with Reference to Forces Arising in Seal Gaps
,”
Energomashinostroenie
,
4
(
1
), pp.
1158
1162
.
4.
Fleming
,
D. P.
,
1979
, “
Stiffness of Straight and Tapered Annular Gas Path Seals
,”
ASME J. Lubr. Tech.
,
101
(
3
), pp.
349
354
. 10.1115/1.3453371
5.
Alexander
,
C. R.
,
Childs
,
D. W.
, and
Yang
,
Z.
,
1995
, “
Theory Versus Experiment for the Rotordynamic Characteristics of a Smooth Annular Gas Seal at Eccentric Positions
,”
ASME J. Tribol.
,
117
(
1
), pp.
148
152
. 10.1115/1.2830591
6.
Kerr
,
B. G.
,
2004
,
Experimental and Theoretical Rotordynamic Coefficients and Leakage of Straight Smooth Annular Gas Seals
,
Texas A&M University
,
College Station, TX
.
7.
Sprowl
,
T.
,
2003
,
A Study of the Effects of Inlet Preswirl on the Dynamic Coefficients of a Straight-Bore Honeycomb Gas Damper Seal
,
Texas A&M University
,
College Station, TX
.
8.
Arghir
,
M.
,
Defaye
,
C.
, and
Frene
,
J.
,
2007
, “
The Lomakin Effect in Annular Gas Seals Under Choked Flow Conditions
,”
ASME J. Eng. Gas Turbines Power
,
129
(
4
), pp.
1028
1034
. 10.1115/1.2434344
9.
Hassini
,
M. A.
, and
Arghir
,
M.
,
2013
, “
Phase Change and Choked Flow Effects on Rotordynamic Coefficients of Cryogenic Annular Seals
,”
ASME J. Tribol.
,
135
(
4
), p.
042201
. 10.1115/1.4024376
10.
Childs
,
D. W.
, and
Arthur
,
S. P.
,
2013
, “
Static Destabilizing Behavior for Gas Annular Seals at High Eccentricity Ratios
,”
ASME Turbo Expo 2013: Turbine Technical Conference and Exposition
,
San Antonio, TX
,
June 3–7
, pp.
V7A
V29A
.
11.
Arghir
,
M.
, and
Mariot
,
A.
,
2015
, “
About the Negative Direct Static Stiffness of Highly Eccentric Straight Annular Seals
,”
ASME J. Eng. Gas Turbines Power
,
137
(
8
), p.
082508
. 10.1115/1.4029624
12.
Benckert
,
H.
, and
Wachter
,
J.
,
1980
, “
Flow Induced Spring Coefficients of Labyrinth Seals for Application in Rotor Dynamics
,”
NASA Conference Publication 2133: Rotordynamic Instability Problems in High-Performance Turbomachinery
,
College Station, TX
,
May 12–14
.
13.
Childs
,
D.
, and
Scharrer
,
J. K.
,
1988
, “
Theory Versus Experiment for the Rotordynamic Coefficient of Labyrinth Gas Seals: Part II—A Comparison to Experiment
,”
ASME J. Vib. Acoust. Stress Reliab. Des.
,
110
(
3
), pp.
281
287
. 10.1115/1.3269514
14.
Childs
,
D.
, and
Scharrer
,
J. K.
,
1986
, “
An Iwatsubo-Based Solution for Labyrinth Seals: Comparison to Experimental Results
,”
ASME J. Eng. Gas Turbines Power
,
108
(
2
), pp.
325
331
. 10.1115/1.3239907
15.
Picardo
,
A.
, and
Childs
,
D. W.
,
2005
, “
Rotordynamic Coefficients for a Tooth-On-Stator Labyrinth Seal at 70 Bar Supply Pressures: Measurements Versus Theory and Comparisons to a Hole-Pattern Stator Seal
,”
ASME J. Eng. Gas Turbines Power
,
127
(
4
), pp.
843
855
. 10.1115/1.1924634
16.
Mehta
,
N. J.
, and
Childs
,
D. W.
,
2014
, “
Measured Comparison of Leakage and Rotordynamic Characteristics for a Slanted-Tooth and a Straight-Tooth Labyrinth Seal
,”
ASME J. Eng. Gas Turbines Power
,
136
(
1
), p.
0125011
. 10.1115/1.4025267
17.
Coleman
,
H. W.
, and
Steele
,
W. G.
,
1999
,
Experimentation and Uncertainty Analysis for Engineers
, 2nd ed.,
Wiley
,
New York
.
You do not currently have access to this content.